Helen Stratford

Helen Stratford: all About Culture

Archive for the ‘construction and repair’ tag

Steam Generator

without comments

Par is an important component of any bath. At the same time for each bath has different types of steam, but for its production is responsible for steam baths. The most specific and difficult to create a pair of Turkish bath. Turkish Bath is a truly extraordinary building, which came to us from ancient Constantinople and absorbed the entire eastern luxuries. For the Turkish bath is characterized by high humidity and relatively low temperature. Equipment used for the Turkish baths should create a gradual and gentle warming with a thick and wet steam.

This pair is very useful for people and allows to deal with various catarrhal diseases. The benefits of visiting a Turkish bath has long been confirmed, even by doctors. It is a steam generator for bath allows you to create an optimal and useful to man the atmosphere in the Turkish bath. It is safe to say that steam bath for continuing the good old tradition of raising the hamam, otherwise referred to as a Turkish bath. After all, before the construction of a Turkish bath in a nearby building install special boilers, which helped create the necessary microclimate in the hammam.

Today, steam baths to establish, as a rule, the wall of the pair. Steam generator for a bath can be used not only in the hamam, but in a traditional Russian steam bath or in the Finnish sauna. Steam generator for a bath is quite versatile, which creates an optimal environment in a bath of any kind. Use a steam bath for very easy and, most importantly, safely. Such equipment does not bring upon the owner of the problems associated with fire or simply failure mode. Modern steam generator for bath will not cause you more hassle associated with malfunctioning equipment bath. Each such unit is equipped with a temperature sensor that makes it easy problems to control the whole process work. In addition, the mode is set, you can not worry about the quality of work steam generator, since the device can maintain the desired temperature of the machine.

Written by Minna

March 1st, 2014 at 8:36 am

Posted in News

Tagged with

Pipeline Parts

without comments

Holes in the pipes with a diameter up to 40 mm for welding nozzles must be performed by drilling, milling or cutting down on the press. The hole diameter should be equal to the inner diameter of the pipe with an allowable deviation Niemi 1 mm. Galvanized steel pipes, parts and components are assembled in the screw with fittings of ductile iron, the nut and flange (with valves and equipment). Galvanized steel pipes with a diameter of 50 mm nominal bore and over are allowed to adopt a compound welding. Compound non-galvanized steel pipes, parts and assemblies of them should be carried out on welded-ke, thread, nut and flange (with valves and equipment). For threaded joints of steel pipes should be used cylindrical pipe thread that runs according to gost 6357 (accuracy class B) thumb on the light tubes and thread – in ordinary and reinforced. Turns pipes in heating systems, gas and heating fol-em perform by bending pipes or the use of seamless weld elbows carbon steel according to gost 17375.

The radius of bending pipes nominal bore diameter to 40 mm inclusive. must be at least 2.5 Dn, and with a diameter of 50 mm nominal bore and more – not less than 3.5 pipe Dn. Do not use billets that are “corrugated” formed by the bending of tubes. In systems hot and cold water piping bends and junctions should be done by setting triangles, tees, crosses, gost 8943 and gost 8944, on-water treatment or bending pipes.

Written by Minna

July 25th, 2012 at 5:35 pm

Posted in News

Tagged with